Auto Code Readers Banner

Flashing CEL

Home
Car Emblems

 

CodeReader kit contents 
PC Vehicle Connection Hardware


Explanation of CodeReader Parts

Please Note: UniPlug sold Separately

(1). Optical Sensor with Black Cloth Cover
For reading "Flash" codes off Check Engine, ABS, Transmission, Airbag (and other) dash lights or LED's on vehicle computers. Plugs into (3) the USB 10 Meter Cable . A suction cup simply and easily positions the light sensor over the dash light or LED's.

(2). Red Wire Clips
Used with "push on" Loose Terminals (6) to allow the Red Wire Clips to safetly clip onto the vehicle diagnostic connector pins to read the fault codes directly. The two Red clips are not polarity sensitive and are protected by an opto coupler to the your PC, Laptop, Computer.

 

(3). USB 10 Meter Cable
Ten meter long USB interface cable between your PC and either the Optical Sensor with Black Cloth Cover (1) or the Red Wire Clips (2) that connect to the vehicle under test.

(4). CodeReader PC Manual
Please note, this manual is built into the CodeReader program, and you can print a paper copy as shown. It has detailed explanation and instructions of how to use the CodeReader.

(6). Loose Terminals
Used to push onto or into the diagnostic connector to safetly connect the Wire Cable (2).

(7). Coloured Wire Links
Used to put the vehicle into diagnostic mode. The Red wire links are are used 95% of the time on Asian vehicles. They have an internal resistor built in to ensure they are completely safe to insert to the diagnostic connector.

(8). Magnetic Strip and Metal Bracket
Used to correctly position the Optical Sensor (1) over the LED's on vehicle computers

(9). Black Jumper Wire
Used with the Loose Terminals (6) to ground some vehicle diagnostic connector pins to put the vehicle into diagnostic mode.

(10). CodeReader Carry Case
Contains all of the above components in one sturdy unit. Case may vary from the one shown.

* SOFTWARE. You can choose between EFI Petrol, EFI Diesel, ABS, Automatic Transmission or Airbag software modules. You need to purchase at least one of the above software modules with the CodeReader Vehicle Connection Hardware.